About a week ago, I reported our progress in modeling worldwide solar radiation with our Energy3D software. While our calculated insolation data for a horizontal surface agreed quite well with the data provided by the National Solar Radiation Data Base, those for a south-facing vertical surface did not work out as well. I suspected that the discrepancy was partly caused by missing the reflection of short-wave radiation: not all sunlight is absorbed by the Earth. A certain portion is reflected. The ability of a material to reflect sunlight is known as albedo. For example, fresh snow can reflect up to 90% of solar energy. People who live in the northern part of the country often experience strong reflection from snow or ice in the winter.
|Figure 1. Calculated and measured insolation on a south-facing surface.|
In the summer, the Sun is high in the sky. A south-facing plate doesn’t get as much energy as in other seasons, especially near the Equator where the Sun is just above your head (such as Honolulu as included in the figures above). However, the ambient reflection can be significant. After incorporating this component into our equations following the convention in the ASHRAE solar radiation model, the agreement between the calculated and measured results significantly improves — you can see this big improvement by comparing Figure 1 (new algorithm) with Figure 2 (old algorithm).
|Figure 2. Results without considering reflected short-wave radiation.|
This degree of accuracy is critically important to supporting meaningful engineering design projects on renewable energy sources that might be conducted by students across the country. We are working to refine our computational algorithms further based on 50 years’ research on solar science. This work will lend Energy3D the scientific integrity needed for rational design, be it about sustainable architecture, urban planning, or solar parks.